AG8為您提供專業的數控卷板機三輥卷板機、四輥卷板機等AG8。

在線谘詢 | 公司簡介 | 聯係AG8
數控卷板機谘詢熱線18061277298

新聞資訊

當前位置:卷板機 > 新聞資訊 >

數控卷板機淺談減速箱設計和它的的校準

文章作者:admin發布時間:2016-05-03 18:16瀏覽次數:

 
 
在這篇文章中AG8重點介紹數控卷板機減速箱設計和它的的校準。
In this article we introduced the numerical control machine reducer design and its calibration.
數控卷板機
卷板機減速箱設計。減速器是由封閉在箱體內的齒輪傳動組成的。常用在原動機與工作機之間作為減速的傳動裝置。高速的電動機經帶傳動和減速器,降低速度後驅動帶式輸送機。由於減速器結構緊湊,效率高,使用維修方便,因而應用廣泛。
Machine reducer design. Reducer is composed of closed in the casing of gear transmission. Between the prime mover and work machine is commonly used as the reduction gear. High speed by the belt drive of the motor and reducer, drive belt conveyor after reducing speed. Because of the speed reducer compact structure, high efficiency, convenient operation and maintenance, and wide application.
數控卷板機
數控卷板機的校準。擰緊螺栓,必要時用填隙片放在螺栓下麵調節水平。用叉車或千斤頂隻從承重梁兩側或承重梁本身的後麵提起機器進行校平,不要靠到機器的其他任何部分。
Calibration of nc machine. Tighten the bolt, if necessary, use filler piece placed under the bolt to adjust levels. With bearing beam of the forklift or jack only from two side or the back of the bearing beam itself mention leveling machine, don't rely on any other parts of the machine.
1.機器必須用精密的水平儀沿兩個軸向校平:
1. The machine must use precision level along the two axial leveling:
2.兩個機架:檢查他們彼此是否完全同相,為了完全同相,必要時使用填隙片(這是正確使用機器的必要條件)。
2. Two racks: check whether they completely in phase, in order to completely in phase, when it is necessary to use filler piece (this is necessary for the proper use of the machine).
3.在上壓輥的縱軸:將水平儀放在上壓輥的正中央,在馬達箱/卡軛方向上。
3. The roller on the vertical axis: put on the center of the roller, the level on the direction of motor/card yoke.
4.在側壓輥的橫向上:將水平儀放在兩個壓輥的兩段靠近每個機架。
4. On the side roller transverse: put two level two close to each frame of a roller.

以上是數控卷板機的減速箱設計和校準。
The above is the reducer design and calibration of numerical control machine.